LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1989 >> Tercel Base, 2D Hatchback, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Servicing - A/T) >> Adjustments >> Gearshift Cable >> Tracker

Gearshift Cable: Tracker

WARNING: This page is about a different car, the 1991 Geo Tracker, 1991 Geo Prizm, 1990 Geo Tracker, and 1990 Geo Prizm. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove center console covers. Place gearshift in Neutral. Looking at gearshift assembly from passengers side, note 2 holes on rear of lever detent bracket, below level of console cover.
  2. Both holes should be aligned. Install a pin in hole to hold gearshift in Neutral. Loosen adjusting nut and lock nut. See Fig 1. Ensure shift lever on transmission is in Neutral.
  3. Tighten adjusting nut and then lock nut. Remove pin from gearshift assembly. Ensure gearshift operates properly in all gear ranges. Install console covers.
Fig 1: Adjusting Gearshift Cable (Tracker)
G90B00753Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals