Removal (Supra 7M-GTE Cam Position Sensor)
- Disconnect negative battery cable. Disconnect cam position sensor connector. Set No. 1 cylinder to TDC. To verify TDC, remove oil filler cap and look for cam lobe facing upward.
- Turn crankshaft counterclockwise approximately 120 degrees. Turn crankshaft clockwise again 10-40 degrees until timing marks on crankshaft pulley and timing cover align.
- Remove air cleaner pipe and hoses. Remove airflow meter and air cleaner cap. Remove power steering reservoir tank. Remove hold-down bolt and cam position sensor.