Manual Hub: Reassembly

On all models, apply grease to sliding surface of all parts. Install seal, detent ball and compression spring into control handle, insert handle in cover and install snap ring. Install retaining spring in clutch with end of spring aligned with first groove cut in full width spline.
Install follower pawl on retaining spring with bent spring and hooded against one of large tabs on pawl. Top ring of retaining spring rides on small tabs. Place compression spring between clutch and cover with large end of spring against cover. Install clutch with pawl tab fitted to control handle.
Install spacer and hub ring on inner hub. Install snap ring. Insert inner hub and hub ring assembly in hub body. Install snap ring. Set control handle and clutch to "free" position. Install cover temporarily and ensure hub turns smoothly. Remove cover for installation procedure.