LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1985 >> Tercel Base >> Repair and Diagnosis >> Engine Performance >> Ignition System - NIPPONDENSO Electronic >> Overhaul >> Disassembly

Ignition System - NIPPONDENSO Electronic: Overhaul: Disassembly

  1. Remove distributor cap, rotor, ignitor and ignition coil dust covers. Note position of ignition coil wiring, then disconnect from terminals. Remove 4 screws and ignition coil.
  2. Remove wiring and condenser. Note position of wires on igniter, then disconnect wires. Remove 2 screws and igniter. Using 2 screwdrivers, carefully pry off set spring and reluctor. See Figure.
  3. Remove vacuum advance diaphragm screw. Disconnect vacuum advance link from breaker plate link, then pull advance unit off. Remove 2 screws, washers, and breaker plate assembly.
  4. Remove centrifugal advance springs. Remove grease plug and screw on top of rotor shaft. Pull out rotor shaft. Remove "E" clip and centrifugal advance weights.
NOTE: If distributor shaft bearing is worn, replace distributor housing and shaft assembly.
scientia non olet · About LEMON Manuals