LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1982 >> Pickup DX, 2.2L Eng VIN L >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Diesel Fuel Injection >> Adjustments >> Injection Pump Timing

Injection Pump Timing

  1. Remove distributor head bolt on injection pump. Install special alignment tool (Toyota Part No. 09275-54010) and dial indicator to distributor head plug.
  2. Set No. 1 or No. 4 cylinder to 45° BTDC on compression stroke. Set dial indicator at zero. Check to see that indicator stays at zero when crankshaft pulley is rocked slightly to left and right.
  3. Turn pulley until No. 1 or No. 4 cylinder is at TDC. Dial indicator should read 0.0394" (1.00 mm). If not, loosen injection pump bolts and all fuel connections.
    Fig 1: Injection Pump Timing
    G09315422Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Install special tool and dial indicator as shown. 

  4. Tilt pump body slightly and recheck injection pump stroke. When correct, tighten bolts and fuel lines, then remove tools and install distributor head bolt and washer.
scientia non olet · About LEMON Manuals