LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1979 >> Corolla Base, 2D Hatchback, Automatic Trans >> Repair and Diagnosis >> Electrical >> Charging Systems >> NIPPONDENSO Alternators >> Overhaul >> Reassembly

NIPPONDENSO Alternators: Overhaul: Reassembly

  1. Press brushes into holder against spring tension. Insert a retaining wire through access hole in rectifier and frame and into brush holder to prevent brushes from falling. Remove wire after assembly to end frame is completed.
  2. Pack multipurpose grease into rear bearing and press bearing onto rotor shaft. Pack drive end bearing with grease and install in drive end frame. Install felt ring, cover and bearing retainer.
  3. Ensure that drive end frame with rotor and rectifier end frame with stator are assembled in original alignment. Tighten body screws and remove brush retaining wire.
scientia non olet · About LEMON Manuals