LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1968 >> Corolla Automatic Trans >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Columns >> Removal & Installation >> Removal

Removal & Installation: Removal

  1. Remove steering wheel from shaft, disconnect turn signal switch wiring harness from under instrument panel, position turn signal in right turn position, loosen attaching screw, and remove turn signal switch.
  2. Loosen steering column attaching screw under turn signal switch, and remove steering column from housing. Remove housing clamp from column tube, but do not loosen housing completely.
    NOTE: If necessary, column bushings may be replaced at this time.
  3. Remove instrument panel undertray, if equipped. Remove steering column clamp (bracket). Disconnect speedometer cable from gear housing and disconnect wiring from oil pressure switch and water temperature sender.
  4. Jack up front of vehicle and support with safety stands at side rails. Turn front wheels to left, then disconnect the pitman arm from sector shaft, using suitable puller (09610-12010). Remove engine stone shield. Unbolt gear housing from body, then pull entire gear and shaft assembly out from underside of vehicle.
scientia non olet · About LEMON Manuals