LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model Y Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electrical System -- Model Y (2 Of 2) >> Keyless Entry And Security >> Module - Body Controller - Security - Remove And Replace >> Remove

Module - Body Controller - Security - Remove And Replace: Remove

  1. Open all doors and lower all windows.
    NOTE: Latch the rear doors with the doors open using a small flat blade screwdriver to prevent an accidental lockout.
  2. Move the driver seat and front passenger seat fully rearward and to the lowest position.
  3. Remove the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
  4. Disconnect 12 V power. See 12 V/LV POWER (DISCONNECT AND CONNECT) .
  5. Open the front and rear console rotating lids.
  6. Open the center console armrest fully.
  7. Release the clips (x4) that attach the rear of the LH decor trim to the center console assembly
    G14834028Courtesy of TESLA, INC.
  8. Remove the screws (x4) that attach the rear of LH center console bright strip to the center console assembly.

    Tip: Use of the following tool(s) is recommended:

    • Torx T20 socket
    G14834029Courtesy of TESLA, INC.
  9. Release the tabs (x3) that attach the rear of the LH center console bright strip to the center console assembly, and then partially release the bright strip from the assembly.
    G14834030Courtesy of TESLA, INC.
  10. Repeat step  7 through step  9 for the RH side of the center console.
  11. Release the clips (x6) that attach the cup holder decor panel to the cup holder assembly, and then separate the cup holder decor panel from the center console assembly.
    G14834031Courtesy of TESLA, INC.
  12. Disconnect the electrical connector from the security body controller module, and then remove the cup holder decor panel from the vehicle.
    G14834032Courtesy of TESLA, INC.
  13. Remove the screws (x2) that attach the security body controller module to the cup holder decor panel, and then remove the security body controller module from the panel.

    Tip: Use of the following tool(s) is recommended:

    • Torx T20 socket
    • Ratchet/torque wrench
    • Wiha TorqueVario-S 0.80 N.m - 2.0 N.m
    • Wiha 1/4" Bit Holder Adapter
    G14834033Courtesy of TESLA, INC.
    G14834034Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals