Steering Column and Wheel - IP, Steering Column, Shroud Lower SUB - Remove And Replace: Install

Position the lower gap hider onto the steering column, and then secure the locator clips (x2), tabs (x4) and datums (x4) that attach the lower gap hider to the steering column.
WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

multimedia:A supplement to the article is available.

Courtesy of TESLA, INC.
Install the bolts (x2) that attach the lower gap hider to the steering column.
1.4 N.m (1.0 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Cordless 1/4 in Dr Ratchet
- Torx T25 socket
- 6 in extension
Courtesy of TESLA, INC.
Install the steering column control module. See STEERING COLUMN AND WHEEL - STEERING COLUMN CONTROL MODULE KOSTAL - REMOVE AND REPLACE
Install the steering column lower shroud. See DASH PANEL - SHROUD, LOWER - REMOVE AND REPLACE .
Install the steering column upper shroud. See DASH PANEL - SHROUD, UPPER - REMOVE AND REPLACE .
Install the steering wheel. See STEERING COLUMN AND WHEEL - STEERING WHEEL - PUR LEATHER - REMOVE AND REPLACE .
Install the driver airbag. See FRONT AIR BAGS - DRIVER AIRBAG ASSEMBLY - REMOVE AND REPLACE .
Install the lower instrument panel. See DASH PANEL - IP LOWER, ASSEMBLY - REMOVE AND REPLACE .
Install the LH instrument panel end cap. See DASH PANEL - END CAP, LH - REMOVE AND REPLACE .
Install the driver footwell cover. See DASH PANEL - DRIVER FOOTWELL COVER ASSEMBLY - REMOVE AND REPLACE .
Connect the LV power. See LV Battery - Li-Ion - Disconnect And Connect .
Remove the rear underhood apron. See UNDERHOOD TRIM - REAR APRON ASSEMBLY - REMOVE AND REPLACE .