Touchscreen - Center Display Assembly - Remove And Replace: Install
- Position the touchscreen into the vehicle, and then connect the harness connectors (x2) to the touchscreen.
- Install the new patch bolts (x2) that attach the center display to the instrumental panel carrier.
16 N.m (11.8 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- Cordless Ratchet/Impact Driver
- 2 in extension
- 10 mm socket
- Ratchet/torque wrench
- Connect the temperature sensor connector.
- Install the instrumental panel service panel. See INFOTAINMENT - TOUCHSCREEN - INSTRUMENT PANEL - SERVICE PANEL - REMOVE AND REPLACE .
- Connect the LV battery power. See LV BATTERY - LI-LON - DISCONNECT AND CONNECT .
- Locally connect a laptop with Toolbox 3 to the vehicle. See TOOLBOX 3 - CONNECT AND DISCONNECT .
- On the laptop, select Actions/Autodiag , and then search for "PING-BASH_DISPLAY". Select PING-BASH_DISPLAY(i) , click Run , and allow the routine to complete.
- Search for "PROC_ICE_X_GATEWAY-SAFE-REBOOT", select PROC_ICE_X_GATEWAY-SAFE-REBOOT(i) , click Run , and allow the routine to complete.
- Remove the diagnostic cable from the port to disconnect Toolbox 3.0 from the vehicle.
- Raise the LH front window and close the LH front door.