Passive Entry - Interior BLE Module - Remove And Replace: Remove
- Open all doors and lower all windows.NOTE: If the vehicle is powered down, latch the rear doors to prevent accidental closure.
- Remove the LH instrument panel end cap. See DASH PANEL - END CAP, LH - REMOVE AND REPLACE .
- Remove the LH upper A-pillar trim. See A - B - C POST INTERIOR TRIM - A - PILLAR UPPER ASSEMBLY, LH - REMOVE AND REPLACE .
- Remove the LH sun visor. See SUN VISORS - SUN VISOR ASSEMBLY, LH - REMOVE AND REPLACE .
- Remove the lower camera cover. See REARVIEW MIRROR - REAR VIEW MIRROR, CAM LOWER COVER - REMOVE AND REPLACE .
- Remove the rear view mirror. See REARVIEW MIRROR - REAR VIEW MIRROR, ASSEMBLY - REMOVE AND REPLACE .
- Repeat step 2 through step 4 for the RH side of the vehicle.
- Remove the LH 2nd row seat side bolster. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW BOLSTER - LH - REMOVE AND REPLACE .
- Remove the 2nd row lower seat cushion. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEAT CUSHION - REMOVE AND REPLACE .
- Remove the LH lower A-pillar trim. See A - B - C POST INTERIOR TRIM - A - PILLAR LOWER ASSEMBLY, LH - REMOVE AND REPLACE .
- Remove the LH lower B-pillar trim. See A - B - C POST INTERIOR TRIM - B - PILLAR LOWER ASSEMBLY, LH - REMOVE AND REPLACE .
- Remove the LH middle B-pillar trim. See TRIM - B-PILLAR - MIDDLE - LH - REMOVE AND REPLACE .
- Remove the LH upper B-pillar trim. See A - B - C POST INTERIOR TRIM - B - PILLAR UPPER ASSEMBLY, LH - REMOVE AND REPLACE .
- Repeat step 8 and step 10 through step 13 for the RH side of the vehicle.
- Release the clips (x6) and locator pin that attach the front of the headliner to the vehicle.NOTE: Take care not to bend the headliner when releasing the clips.
If the metal clips are damaged during releasing, replace them with new metal clips. - Disconnect the LV battery power. See LV BATTERY - LI-LON - DISCONNECT AND CONNECT .
- Pull the red locking tab to disengage the lock, and then hold and pull it again to release the connector.
- Remove the bolt that attaches the BLE module to the vehicle, and then release the clip and remove the BLE module.
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Ratchet/torque wrench
- 4 in extension