LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model 3 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Electrical System (2 Of 2) -- Model 3 >> Keyless Entry and Security >> Passive Entry - Rear BLE Module - Remove And Replace >> Install

Passive Entry - Rear BLE Module - Remove And Replace: Install

  1. Fasten the tab and datums (x2) that attach the BLE module to the rear fascia.
    G16596395Courtesy of TESLA, INC.
  2. Connect the rear BLE module electrical connector.
    G16596396Courtesy of TESLA, INC.
  3. Install the rear fascia. See BUMPER AND FASCIA - REAR BUMPER FASCIA - REAR FASCIA - REMOVE AND INSTALL .
  4. Connect a laptop with Toolbox 3 to the vehicle. See TOOLBOX 3 - CONNECT AND DISCONNECT .
  5. In Toolbox, click the Actions/Autodiag  tab, type "Endpoint" in the search field.
  6. Click on TEST-SELF_VCSEC_X_ENDPOINT-COMM(i) , and then click Run Network  and allow the routine to complete.
  7. Disconnect the laptop with Toolbox 3 from the vehicle. See TOOLBOX 3 - CONNECT AND DISCONNECT .
  8. Reinstall the vehicle firmware. See SOFTWARE REINSTALL - TOUCHSCREEN .
scientia non olet · About LEMON Manuals