Body Controllers - Assembly, Front Controller GEN 3 - Remove And Replace: Remove
- Remove the cowl screen panel. See UNDERHOOD TRIM - ASSEMBLY, COWL SCREEN, LHD - REMOVE AND REPLACE .
- Disconnect LV power. See LV BATTERY - LI-LON - DISCONNECT AND CONNECT .
- Disconnect the thermal harness from the front body controller module connector.
- Remove the bolts (x2) that attach the front body controller module cover to the front body controller module, and then remove the cover.
Tip: Use of the following tool(s) is recommended:
- Flex head ratchet/flex head torque wrench
- 4 in extension
- 10 mm socket
- Ratchet/torque wrench
- Disconnect the electrical harness from the front body controller module connectors (x5).
- Remove the bolt that attaches the ground strap to the lower right side of the front body controller module, and then remove the ground strap from the module.
Tip: Use of the following tool(s) is recommended:
- Flex head ratchet/flex head torque wrench
- 4 in extension
- 10 mm socket
- Ratchet/torque wrench
- Remove the bolts (x3) that attach the front body controller module to the body. Use of the following tool(s) is recommended:
- Flex head ratchet/flex head torque wrench
- 10 in extension
- 10 mm socket
- Ratchet/torque wrench
- Tilt front controller forward for access, and then release LV negative harness clip from front controller.WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.multimedia:A supplement to the article is available.
- Remove the front controller from vehicle.