Body Controllers - Assembly, Right Controller - Remove And Replace: Remove
- Open all doors and lower all windows.
- Remove the rear underhood apron. See UNDERHOOD TRIM - REAR APRON ASSEMBLY - REMOVE AND REPLACE .
- Remove the driver footwell cover. See DASH PANEL - DRIVER FOOTWELL COVER ASSEMBLY - REMOVE AND REPLACE .
- Remove the RH instrument panel end cap. See DASH PANEL - END CAP, LH - REMOVE AND REPLACE .
- Remove the glove box. See DASH PANEL - GLOVE BOX WITH USB ASSEMBLY - REMOVE AND REPLACE .
- Remove the LH lower A-pillar trim. See A - B - C POST INTERIOR TRIM - A - PILLAR LOWER ASSEMBLY, LH - REMOVE AND REPLACE .
- Release the lock, and then disconnect the RH front door electrical connector from the RH body controller module.
- Release the connector lock, and then disconnect the front passenger seat electrical connector from the RH body controller module.
- Disconnect the J10 instrument panel electrical connector from the RH body controller module.
- Disconnect the J11 HVAC electrical connector from the RH body controller module.
- Release the electrical harness clips (x2) from underneath the IP carrier.
- Fold back the RH front carpet.
- Release harness clip from car computer.
- Disconnect connector from the right body harness.
- Disconnect connectors from car computer.
- Release the harness clip from the RH body controller.
- Release the connector lock, and then disconnect the J1 power electrical connector from the RH body controller module.
- Disconnect the J12 body electrical connector from the RH body controller module.
- Release the connector lock, and then disconnect the J4 body electrical connector from the RH body controller module.
- Release the connector lock, and then disconnect the J2 body electrical connector from the RH body controller module.
- Disconnect the J5 body electrical connector from the RH body controller module.
- Disconnect the J6 underhood storage unit electrical connector from the RH body controller module.
- Release the clip that attaches the RH front carpet to the body at the RH A-pillar.
- Release the RH body harness from the RH body controller and A-pillar and move aside.
- Remove and discard the nut that attaches the RH body controller module to the body.WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.multimedia:A supplement to the article is available.
- Maneuver the RH body controller module from under the IP, and then remove it from the vehicle.