Steering Controller - Remove And Replace: Remove
- Remove the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
- Disconnect 12 V power. See 12 V/LV POWER (DISCONNECT AND CONNECT) .
- Remove the driver airbag. See Airbag - Driver (Remove and Replace) .
- Disconnect the steering wheel electrical wiring harness from the connector.
- Release the clips that attach the horn assembly, and then move the horn assembly to the side.
- Remove the screws (x4) that attach the bright surround to the steering wheel, and then remove the surround.
Tip: Use of the following tool(s) is recommended:
- T20 socket
- Disconnect the electrical harness from the steering wheel controls ECU connector.
- Remove the screws (x2) that attach the steering wheel controls ECU to the bright surround, and then remove the ECU from the surround.
Tip: Use of the following tool(s) is recommended:
- T10 Torx bit