Wheels - Axle Set - Remove And Install: Installation
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Tesla Model S, 2019 Tesla Model S, 2018 Tesla Model S, 2017 Tesla Model S, and 2016 Tesla Model S. However, it is still accessible from the selected car via links, so may be relevant.
Installation procedure is the reverse of removal, except for the following:
CAUTION:
Tighten the lug nuts evenly using a diagonal sequence.
CAUTION:
An impact wrench or electric wrench can be used only during the initial threading of the lug nuts. Use a torque wrench to fully tighten the lug nuts.
CAUTION:
Use a 6 point socket to tighten tall lug nuts. Do not use a 12 point socket or a specialty socket on tall lug nuts.
NOTE:
Any time the TPMS sensors are not reinstalled in the same locations (for example, when rotating the tires), perform the TPMS sensor ID learn procedure:
- Baolong TPMS: , refer to TPMS Sensor - ID Learn Procedure - Baolong .
- Continental TPMS: , refer to TPMS Sensor - ID Learn Procedure - Continental .
NOTE:
If wheels of a different diameter are installed:
- Baolong TPMS: Use Toolbox to change the vehicle configuration, then reset the TPMS thresholds, refer to TPMS - Set Thresholds .
- Continental TPMS: Use Toolbox to change the vehicle configuration.