Tire Rotation: Procedure
- Remove all 4 wheels. See WHEEL (REMOVE AND INSTALL) .
- Check if the tires are offset or directional.NOTE: Directional tires are identified with an arrow indicating the direction of rotation on the sidewall.
- Reinstall the wheels according to the type of tires.
Move front tires to opposite side in rear. Move rear tires only to front.
NOTE: Mobile Service technicians, factory tires may be rotated as indicated in "Non-Directional Tires, Front and Rear Different Size".Non-Direction Tires, All Tires Sam Size
Move LH to RH. Do not move front to rear.
Non-Directional Tires, Front and Rear Difference Size
Move front tires to rear. Do not move from LH to RH.
- Install all 4 wheels. See WHEEL (REMOVE AND INSTALL) .
- Reset the tire estimates using one of the following methods.
- On the touchscreen, touch Controls > Service > Chassis > Alignment & Tires > Reset Learned Tire Values and then follow the on-screen instructions.
- Use Toolbox 3:
- Connect a laptop with Toolbox 3 to the vehicle.
- In Toolbox, click the Actions tab, and then search for "Reset Tire Estimates".
- Click PROC_DIR_CLEAR-LEARNT-TIRE-OFFSET , and then click Run and allow the routine to complete.
- Disconnect Toolbox and remove the laptop from the vehicle.