Center Console (2.0) (Structural Pack) - Remove And Install: Install
- With assistance, position the center console onto the rails, and then push the assembly forward.CAUTION: Force applied must be parallel to the rails.
- Connect the center console harness electrical connector.NOTE: The connector is located behind the LH center console side carpet.
- Connect LV power. See 12 V/LV POWER (DISCONNECT AND CONNECT)
- Install the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
- Install the bolts (x2) that attach the center console to the lower rails.
9.5 N.m (7.0 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- 8 mm socket
- Install the center console lower rear panel. See PANEL - LOWER REAR - CENTER CONSOLE (REMOVE AND REPLACE) .
- Move the front seats rearward.
- Install the bolt that attaches the RH side of the center console to the instrument panel.
6.5 N.m (4.8 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- T30 socket
- Connect the USB harness electrical connector at RH front of the center console.
- Install the RH center console side panel. See Side Panel - Center Console - LH (Remove And Replace) .
- Install front passenger floor mat.
- Move the front passenger seat to the original position.
- Install the bolt that attaches the LH side of the center console to the instrument panel.
6.5 N.m (4.8 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- T30 socket
- Install the LH center console side panel. See.Side Panel - Center Console - LH (Remove And Replace)
- Install driver floor mat.
- Move the driver seat to the original position.
- Raise all the windows and close all the doors.