Adjustable Top Loop - Remove and Replace: Remove
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Tesla Model 3, 2022 Tesla Model 3, 2021 Tesla Model 3, 2020 Tesla Model 3, and 2019 Tesla Model 3. However, it is still accessible from the selected car via links, so may be relevant.
- Open both LH doors and lower both LH windows.
- Move the LH front seat fully forward.
- Release the clips that attach the LH upper B-pillar trim to the vehicle.
Tip: Release the clips at the bottom of the LH upper B-pillar trim first, and then release the clips at the top of the trim.
- Set the LH upper B-pillar trim aside.
- Remove and discard the patchbolt that attaches the upper D-ring to the B-pillar.
Tip: Use of the following tool(s) is recommended:
- Torx T45 socket
- 3/8 in std ratchet
- 3/8 in flex head torque wrench (installation only)
- 3 in extension
- Remove the bolt that attaches the adjustable top loop to the B-pillar.NOTE: The patchbolt is permanently attached to the adjustable top loop.
Tip: Use of the following tool(s) is recommended:
- Torx T47 socket
- 3/8 in std ratchet
- 3/8 in flex head torque wrench (installation only)
- Pull the top of the adjustable top loop away from the B-pillar, and then slide upwards to remove the adjustable top loop from the vehicle.