Adjustable Top Loop - Remove and Replace: Install
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Tesla Model 3, 2022 Tesla Model 3, 2021 Tesla Model 3, 2020 Tesla Model 3, and 2019 Tesla Model 3. However, it is still accessible from the selected car via links, so may be relevant.
- Position the adjustable top loop on the B-pillar, and then install the new patchbolt that attaches the adjustable top loop to the B-pillar.
20 N.m (14.7 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- Torx T47 socket
- 3/8 in std ratchet
- 3/8 in flex head torque wrench (installation only)
- Install the new patchbolt that attaches the upper D-ring to the B-pillar.
20 N.m (14.7 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- Torx T45 socket
- 3/8 in std ratchet
- 3/8 in flex head torque wrench (installation only)
- 3 in extension
- Lower the adjustable top loop to align it with the LH upper B-pillar trim.
- Insert the top portion of the LH upper B-pillar trim under the headliner to align the clips, and then press the bottom of the trim to fully engage all of the clips.NOTE: Make sure the rubber door seals completely overlap the trim.