Steering Yoke/Wheel - Remove And Replace: Install

Install the steering yoke/wheel to the steering column.
NOTE: Align the splines on the steering column.

NOTE: The splines are indexed and the steering yoke/wheel can only be installed in the correct position.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
With a new bolt, install the steering yoke/wheel to the steering column.
NOTE: 80 N.m (59.0 lbs-ft)

NOTE: Bolt PN - 1036655-00-A.

NOTE: Note that the steering yoke/wheel is splined to the column.

Tip: Use of the following tool(s) is recommended:
- 3 in extension
- 10 mm hex (H10 bit) socket
- Flex head ratchet/flex head torque wrench
Courtesy of TESLA, INC.
Connect the steering yoke/wheel electrical connector to the steering yoke/wheel.

Courtesy of TESLA, INC.
Install the driver airbag. See: AIRBAG - DRIVER - REMOVE AND REPLACE .
NOTE: If the vehicle is retrofitted with a round steering wheel, a round steering wheel airbag should be in installed. Please read the part label to confirm the airbag type.
Connect LV power. See LV Power (Disconnect and Connect) .
Install the rear underhood apron. See:Underhood Apron - Rear (Remove and Replace) .
Reinstall the vehicle software via touchscreen. See: FIRMWARE REINSTALL - TOUCHSCREEN .
Raise the LH front window and close the LH front door.