LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model S Performance >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Electrical System -- Model S) >> Keyless Entry And Security >> Casing - Key Fob - Remove And Replace >> Installation

Casing - Key Fob - Remove And Replace: Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Tesla Model S, 2019 Tesla Model S, 2018 Tesla Model S, 2017 Tesla Model S, and 2016 Tesla Model S. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the internal structure in the top panel.
    G15035180Courtesy of TESLA, INC.
  2. Place the 3 buttons in the internal structure.
    NOTE: Place the shortest button in the front hole, the tallest button in the middle hole, and the medium-length button in the rear hole.
    NOTE: If a button does not sit flush with the internal structure, it is in the wrong position.
    G15035181Courtesy of TESLA, INC.
  3. Insert the circuit board with the buttons facing down.
    CAUTION: Take care not to damage component(s).
  4. Install the bottom cover.
  5. Install the side covers.
    NOTE: Position the tabs on the side cover in the notches at the top of the transmitter, then rotate the side cover into position.
  6. Install the battery.
scientia non olet · About LEMON Manuals