- Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect)
.
- Select 'Dashboards' tab and select 'Radar Calibration Dashboard"
- Select 'Radar Calibration Routine' and click 'Run'
- Select 'Calibration Instructions' and click 'Run"
NOTE:
Take the time to read the calibration instructions, Select "OK" after reading instructions to close window
- Select "Service Radar Alignment" and click "Run"
NOTE:
Be prepared to go on a test drive before beginning routine. Shift vehicle into Drive beforehand. Starting the routine will begin the calibration process, If drive does not occur process may time out
- Drive vehicle as instructed by the software, and monitor progress bar until radar calibration is complete
NOTE:
Once you initiate the calibration process, be prepared to go for a drive. When driving, keep in the right most lane (if on a two lane road), and try to keep above 30 mph. The routine will take roughly around 5 minutes, after which you will see the results pop-up on the screen
NOTE:
If the test drive shows the vehicle to track poorly or pull to the side, or if steering is sloppy or off center, then perform a four wheel alignment check. See Four Wheel Alignment Check
.
- Disconnect Toolbox 3 from vehicle and remove laptop and ethernet diag kit