Module - Body Controller - RH (RHD) - Remove and Replace: Remove
- Disconnect 12V power. See 12V/LV POWER (DISCONNECT AND CONNECT) .
- Remove the RH footwell duct. See DUCT - FOOTWELL - RH (RHD) (REMOVE AND REPLACE) .
- Remove the RH middle A-pillar trim. See TRIM - A-PILLAR - MIDDLE - LH (REMOVE AND REPLACE) .
- Remove the RH lower A-pillar trim. See TRIM - A-PILLAR - LOWER - LH (REMOVE AND REPLACE) .
- Release the clips that attach the RH front carpet to the RH footwell.
- Fold back the RH front carpet.
- Disconnect the electrical connectors from the RH body controller module.
- Release the lock, and then disconnect the RH front door electrical connector from the RH body controller module.
- Release the connector lock, and then disconnect the driver seat electrical connector from the RH body controller module.
- Disconnect the instrument panel harness coaxial cable from the RH body controller module.
- Disconnect the HVAC electrical connector from the RH body controller module.
- Disconnect the front harness connector from the RH body controller module.
- Release the clip that attaches the inline electrical connector to the RH body controller module, and then disconnect the electrical connector.
- Remove and discard the nut that attaches the 12V power cable to the LH body controller module.
Tip: Use of the following tool(s) is recommended:
- 10 mm 12-point deep socket
- 1/4 in std ratchet
- 1/4 in torque wrench (installation only)
- 4 in extension
- Remove the DCDC positive cable from the RH body controller module.
Tip: Use of the following tool(s) is recommended:
- 10 mm 12-point deep socket
- 1/4 in std ratchet
- 1/4 in torque wrench (installation only)
- 2 in extension
- Connect the body 2 electrical connector to the LH body controller module.
- Connect the body 1 electrical connector to the LH body controller module.
- Connect the body 3 electrical connector to the LH body controller module.
- Disconnect the 3 inline electrical connectors at the RH lower A-pillar area.
- Release the clip that attaches the electrical harness to the RH lower A-pillar area.
- Release the clips that attach the RH body electrical harness to the RH body controller module.
- Move the RH body harness away from the RH body controller module.
- Release the clip that attaches the wiring harness to the RH body controller module.
- Remove and discard the nut that attaches the RH body controller module to the body.
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- 1/4 in std ratchet
- 1/4 in torque wrench (installation only)
- 2 in extension
- Slide the RH body controller upwards to release the W-clip, then move the RH body controller out from underneath the instrument panel, and then remove the RH body controller from the vehicle.
- If the RH body controller module has a shroud installed, release the clips that attach the shroud to the module.NOTE: A shroud should be installed on the new body controller module even if one was not present during removal.