IP Carrier - Remove and Install: Install

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Tesla Model 3, 2022 Tesla Model 3, 2021 Tesla Model 3, 2020 Tesla Model 3, and 2019 Tesla Model 3. However, it is still accessible from the selected car via links, so may be relevant.

Installation procedure is the reverse of removal, except for the following:

Model 3 built before August 22, 2017 only: Refer to Toolbox Article 39237 to determine if felt tape should be applied to prevent NVH issues with the top pad.
Clean the lower inside of the windshield.
Align the tabs of the IP carrier with the channels in the body below the windshield.
Install the foam half-circle into the center of IP carrier at base of windshield.