Drive Unit - Front (2nd Generation) - Remove And Replace: Remove

Remove the 2nd generation front drive unit from the vehicle. See DRIVE UNIT - FRONT (2ND GENERATION) (REMOVE AND INSTALL) .
Attach the drive unit sling tool to the front drive unit and hand tighten the bolts to the sling tool.
NOTE: Follow the mounting points for the Model 3 rear drive unit as shown with the tool instructions.

Courtesy of TESLA, INC.
Put the drive unit stand underneath the gantry, and then secure the sling tool to the gantry.

Courtesy of TESLA, INC.
Raise the sling tool so that there is a slight tension on the sling tool cables.

Courtesy of TESLA, INC.
Raise the sling tool to lift the front drive unit off the motor stand.

Courtesy of TESLA, INC.
Put the front drive unit above an empty crate made for the front drive unit or use a pallet, and then lower the front drive unit onto the crate or pallet.