LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2019 >> Model X 100D >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Wheel And Tires -- Model X >> Tire Pressure Monitoring System (TPMS) >> TPMS Sensor - ID Learn Procedure >> Setup

TPMS Sensor - ID Learn Procedure: Setup

  1. Press the Power button and watch the display. When the display shows "ATEQ VT30", note the version number:
    • If the version is EA1-07, refer to TN-14-92-005, "ATEQ TPMS Tool Firmware Update" to update the tool's firmware.
    • If the version is higher than EA1-07, continue this procedure.
  2. In the Main Menu, use the up and down arrows to select Vehicle Selection  , then press the Enter  (down left arrow) button.
  3. Use the up and down arrows to select Tesla  , then press the Enter  button.
  4. Use the up and down arrows to select Left Front  .
  5. Hold the ATEQ tool near the valve stem on the left front tire, then press and hold the Read  button until the sensor is read.
  6. Repeat steps 4  and 5  for the 3 remaining tires.
  7. Connect a laptop with Toolbox 3 to the vehicle. See TOOLBOX 3 - CONNECT AND DISCONNECT .
  8. Unlock the vehicle gateway. See GATEWAY UNLOCK .
  9. In Toolbox 3, click the Actions  tab, type "TPMS-LEARN" into the search field, click PROC_TPMS_X_TPMS-SENSOR-LEARN, click Run  , and allow the routine to complete.
  10. Disconnect the laptop with Toolbox 3 from the vehicle. See TOOLBOX 3 - CONNECT AND DISCONNECT .
scientia non olet · About LEMON Manuals