Shaft - Steering Column - Intermediate Upper - Remove And Replace: Installation

Installation procedure is the reverse of removal, except for the following:

1. Ensure that the upper intermediate shaft to column marks align correctly.
2. When using toolbox 3, go to step  6.
3. Connect a laptop with Toolbox 2.0 to the vehicle.
4. In Toolbox, select Panels > Steering > Power Steering (EPAS) Control  . Click the Start/Play  button and follow the onscreen instructions.
   NOTE: After calibrating EPAS, drive the vehicle for a minimum of 5 minutes before returning the vehicle to the customer.
5. Disconnect the laptop from the vehicle and discontinue this procedure.
6. Connect a laptop to the diagnostic port of the vehicle, and then use Toolbox 3 to locally connect to the vehicle. See Toolbox 3 (Connect and Disconnect) .
7. Unlock the vehicle gateway for diagnostic communication. See Gateway Unlock .
8. Calibrate the steering rack, using Toolbox 3:
   NOTE: Steering rack calibration is only required if the vehicle is equipped with a Bosch type steering rack.
   1. Select the Actions  tab and search for "Bosch EPAS Calibration".
   2. Select the ODIN routine PROC_EPAS_X_CALIBRATION  , and then click the link of the routine.
   3. Click RUN  , and allow the routine to complete.
      NOTE: After calibrating EPAS, drive the vehicle for a minimum of 5 minutes before returning the vehicle to the customer.
9. Disconnect the laptop from the vehicle.