Module - Body Controller - RH (LHD) (Heat Pump) - Remove and Replace: Remove
- Open the front doors and lower the windows.
- Remove the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
- Disconnect 12V power. See 12V/LV POWER (DISCONNECT AND CONNECT) .
- Remove the LH instrument panel end cap. See END CAP - INSTRUMENT PANEL - LH (REMOVE AND REPLACE) .
- Remove the LH air wave end cap. See END CAP - AIR WAVE - LH (REMOVE AND REPLACE) .
- Repeat steps 4 and 5 for the RH side of the vehicle.
- Remove the main instrument panel decor trim. See DECOR TRIM - INSTRUMENT PANEL - MAIN (REMOVE AND REPLACE) .
- Remove the RH middle A-pillar trim. See TRIM - A-PILLAR - MIDDLE - LH (REMOVE AND REPLACE) .
- Remove the RH lower A-pillar trim. See TRIM - A-PILLAR - LOWER - LH (REMOVE AND REPLACE) .
- Remove the passenger footwell cover. See COVER - FOOTWELL - PASSENGER (LHD) (REMOVE AND REPLACE) .
- Remove the front passenger knee airbag. See AIRBAG - KNEE - FRONT PASSENGER (REMOVE AND REPLACE) .
- Remove the glove box. See GLOVE BOX - WITH KNEE AIRBAGS (REMOVE AND REPLACE) .
- Remove the RH front floor mat.
- Remove the RH center console side panel carpet. See SIDE PANEL - CENTER CONSOLE - LH (REMOVE AND REPLACE) .
- Release the clips (x3) that attach the RH front carpet to the body at the RH A-pillar.
- Fold back the RH front carpet.NOTE: Release the seat harness from the clips at the RH door sill to allow the carpet to further fold back.
- Remove the nuts (x2) that attach the RH side carpet locator bracket.NOTE: Later vehicles may use 2x push clips instead.
- Release the connector lock, and then disconnect the J7 door electrical connector from the RH body controller module.
- Release the connector lock, and then disconnect the J9 front passenger seat electrical connector from the RH body controller module.
- Disconnect the J10 instrument panel electrical connector from the RH body controller module.
- Disconnect the J11 HVAC electrical connector from the RH body controller module.
- Release the connector lock, and then disconnect the J1 power electrical connector from the RH body controller module.
- Release the connector lock, and then disconnect the J4 body electrical connector from the RH body controller module.
- Disconnect the RH body harness connector.
- Release the harness clips below the IP carrier.
- Disconnect the J6 underhood storage unit electrical connector from the RH body controller module.
- Release the connector lock, and then disconnect the J2 body electrical connector from the RH body controller module.
- Disconnect the J12 body electrical connector from the RH body controller module.
- Disconnect the J5 body electrical connector from the RH body controller module.
- Disconnect the connectors from the harness clip at the RH lower A-pillar area.
- Remove the RH body harness clip from the lower A-pillar area.
- Remove the RH body harness clips from the RH body controller module.
- Move the RH body harness away from the RH body controller module.
- Remove and discard the nyloc nut that attaches the RH body controller module to the vehicle.
- Slide the RH body controller module upwards to release the W clip, maneuver the RH body controller module out from under the IP, and then remove the RH body controller module from the vehicle.