LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2016 >> Model S 90D >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Maintenance, Inspection And Service -- Model 3) >> Service Modes >> Toolbox 3 - Connect and Disconnect >> Complete Connect

Complete Connect

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Tesla Model 3, 2022 Tesla Model 3, 2021 Tesla Model 3, 2020 Tesla Model 3, and 2019 Tesla Model 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the condition of the connectors of the laptop with Toolbox 3, the vehicle interface cable, and the vehicle interface connector.
    NOTE: If the vehicle interface cable is damaged in any way, do not use it.
  2. Open the LH front door.
  3. Connect the vehicle interface cable to the laptop and to the vehicle interface connector located in the LH footwell.
    NOTE: Perform a push-pull-push check of each of the connections.
    G00643671Courtesy of TESLA, INC.
  4. If powered off, press the brake pedal to power on the vehicle drive rails.
  5. If powered off, power on the laptop, sign in and open a web browser to the Toolbox 3 website.
  6. In Toolbox 3, click the grey circle in the upper right corner to open the connection window.
  7. From the drop-down, select Connect Locally  , and then click Connect  .
    NOTE: When the connection is successfully established, the grey circle becomes green.
    G00643672Courtesy of TESLA, INC.
  8. Click the green circle to close the connection window.
  9. Return to the procedure that required a laptop with Toolbox 3 connection to the vehicle.
scientia non olet · About LEMON Manuals