Sensor - Impact - B-Pillar - Remove And Replace: Notes
Last modified: 18/11/2022 10:19:40
WARNING:
Make sure 12V power has been disconnected for at least 2 minutes before disconnecting electrical harnesses from SRS components (sensors, modules, airbags, etc.). Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see Air Bag and Supplementary Restraint System (SRS) Precautions
.
NOTE:
In the event of an airbag or seat belt tensioner deployment, certain airbag and seat belt components must be replaced, and other components must be inspected for damage. Refer to SRS INSPECTION AND COMPONENT REPLACEMENT
for a specific list of items that must be inspected and replaced.
NOTE:
This procedure might contain steps to use Toolbox 2 to supplement the service operation. Toolbox 2 and its Panels are being phased out and replaced with Toolbox 3 routines.