Actuator - Pedestrian Protection - LH - 2nd Generation - Remove And Replace: Installation

Installation procedure is the reverse of removal, except for the following:

• If the actuators deployed, remove and replace the pressure tube sensor. See #GUID-59D0EF38-22DF-41A1-BFE5-3DAA753A3DC4.
• If the actuators deployed, remove and replace the hood hinges. See Hinge - Hood - LH (Remove and Replace) .
• If the actuators deployed, inspect the following for damage and replace as necessary:
  • Hood
    NOTE: Inspect for deformation in the plastic above the hood hinges, the surface above the hinges, and the surface above the striker.
  • Primary hood latch
  • Secondary hood latch
  • Hood striker
• After all components are reinstalled, connect a laptop with Toolbox to the vehicle and perform the following steps:
  1. In Toolbox, click Panels  > Alerts  > DTCs  .
  2. Press the brake pedal to turn on the drive rails.
  3. In the lower right corner of Toolbox, click Read DTCs  , and after any alerts are displayed, click Clear DTCs  .
  4. In Toolbox, click Panels  > Restraint System  > Airbag Configuration for Bosch RCM  .
  5. Click the "Play" button to begin Bosch RCM configuration.
  6. After the Bosch RCM, ESP, and IMU are configured, click Finish  .
  7. Disconnect the laptop from the vehicle.