Module - Body Controller - RH - Remove And Replace: Install
WARNING: This page is about a different car, the 2024 Tesla Model S, 2023 Tesla Model S, 2022 Tesla Model S, and 2021 Tesla Model S. However, it is still accessible from the selected car via links, so may be relevant.
- Install the RH body controller module to the vehicle.NOTE: Attach the tab onto the body and align into the body stud
- Install a new nut that attaches the RH body controller to the body.
6 Nm (4.4 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- 10 mm deep socket
- Flex head ratchet/flex head torque wrench
- Ratchet/torque wrench
- Position the harness bundle back to the RH body controller.
- Fasten the clips (x2) that attach the RH harness bracket to the body.
- Connect the door electrical connector (J11) to the RH body controller module.
- Connect the door electrical connector (J10) to the RH body controller module.
- Connect the dash electrical connector (J12) to the RH body controller module.
- Fasten the clips (x2) that attach the harness connectors to the RH body controller module.
- Connect the harness connectors (x2) to the RH body controller module.
- Connect the power electrical connector (J14 X056) to the RH body controller module.
- Connect the body 6 electrical connector (J8 X062) to the RH body controller module.
- Connect the body 2 electrical connector (J3 X051) to the RH body controller module.
- Connect the understood storage unit electrical connector (J9 X050) to the RH body controller module.
- Connect the body electrical connector (J2 X050) to the RH body controller module.
- Connect the body electrical connector (J4) to the RH body controller module.
- Connect the body 5 electrical connector (J6/J7 X060A/B) to the RH body controller module.
- Connect the body 4 electrical connector (X054) to the RH body controller module.
- Return the RH main carpet back into place.
- Install the front passenger knee airbag. See Knee Airbag - Front Passenger - Remove And Replace
.NOTE: No need to install the front passenger knee airbag cover.
- Install the passenger footwell cover. See Cover - Footwell - Passenger - Remove And Replace .
- Connect LV power. See LV Power - Disconnect And Connect .
- Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 - Connect And Disconnect .
- In Toolbox 3, click the Actions tab, type "Service_Redeploy" into the search field, click UPDATE_SERVICE-REDEPLOY, click Run , and allow the routine to complete.
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .
- Install the RH lower A-pillar trim. See Trim - A-Pillar - Lower - LH - Remove And Replace .
- Install the RH middle A-pillar trim. See Trim - A-Pillar - Middle - LH - Remove And Replace .
- Move the RH front seat back to its original position.
- In Toolbox 3, click the Actions tab, type "VCRIGHT replacement" into the search field, click PROC_VCRIGHT_X_POST-REPLACEMENT-PROCEDURE, click Run , and allow the routine to complete.
- Disconnect Toolbox and remove the laptop from the vehicle. See Toolbox 3 - Connect And Disconnect .