Module - Body Controller - Front - Remove And Replace: Remove
WARNING: This page is about a different car, the 2024 Tesla Model S, 2023 Tesla Model S, 2022 Tesla Model S, and 2021 Tesla Model S. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .
- Disconnect LV power. See LV Power (Disconnect And Connect) .
- Remove the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace) .
- Remove the front underhood apron. See Underhood Apron - Front (Remove and Replace) .
- Remove the underhood storage unit access panel. See Underhood Storage Unit Access Panel (Remove and Replace) .
- Remove the underhood storage unit carpet.
- Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace) .
- Release the upper locking connectors (x2) on the front body controller module.NOTE: Push in locking tabs, and then lift the levers to release.
- Release the LH middle locking connector on the front body controller module.NOTE: Push in locking tab, and then lift the lever to release.
- Release RH middle locking connectors (x2) on the front body controller module.NOTE: Slide the locking mechanism outwards to release.
- Release the lower locking connectors (x2) on the front body controller module.NOTE: Slide the red locking tab outwards to release.
- Remove the bolt that attaches the ground cable for the front body controller module.NOTE: 10 mm, 10 N.m
- Remove the bolts (x3) that attach the front body controller module to the body.NOTE: 10 mm, 10 N.m
- Remove front body controller module from vehicle, and then release the ground cable from the multi system beam.NOTE: 2x locating tabs, 1x ground cable