Module - Battery Controller - Remove And Replace: Install
WARNING: This page is about a different car, the 2024 Tesla Model S, 2023 Tesla Model S, 2022 Tesla Model S, and 2021 Tesla Model S. However, it is still accessible from the selected car via links, so may be relevant.
- Position the battery controller module into the vehicle.
- Fasten the clip that attaches the harness to the battery controller module.
- Connect the electrical connectors (x5) to the battery controller module.
- Fasten the clip that attaches the harness to the battery controller module.
- Install the bolt that attaches the battery controller module ground cable to the vehicle.
9 Nm (6.6 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- 10 mm deep socket
- Flex head ratchet/flex head torque wrench
- External Torx E10 5-Lobe
- Install the bolt and nut that attach the battery controller module to the vehicle and tilt the module for access.
Tip: Use of the following tool(s) is recommended:
- 10 mm deep socket
- 6 in extension
- Flex head ratchet/flex head torque wrench
- Install the bolts and nut that attach the LH V-brace to the vehicle.
Tip: Use of the following tool(s) is recommended:
- 10 mm deep socket
- 4 in extension
- Flex head ratchet/flex head torque wrench
- Install the cowl screen panel. See Panel - Cowl Screen - Remove And Replace .
- Install the LH wiper arm. See Wiper Arm - LH - Remove And Replace .
- Install the LH shock tower cover. See Cover - Shock Tower - LH - Remove And Replace .
- Install the LH underhood apron. See Underhood Apron - LH - Remove And Replace .
- Repeat step 9 through step 11 on the RH side of the vehicle.
- Connect LV power. See LV Power - Disconnect And Connect .
- Perform a software reinstall. See Firmware Reinstall - Touchscreen or Firmware Reinstall - Toolbox .
- Adjust the headlights. See Headlights - Adjust - NA (Tool Method) or Headlights - Adjust (Global) (Tool Method) .
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .