LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2014 >> Model S Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Safety And Restraint Systems -- Model 3) >> Airbags >> Module - Restraint Control (Non-Heat Pump) Remove and Replace >> Remove

Module - Restraint Control (Non-Heat Pump) Remove and Replace: Remove

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Tesla Model 3, 2022 Tesla Model 3, 2021 Tesla Model 3, 2020 Tesla Model 3, and 2019 Tesla Model 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. On the touchscreen, touch Controls  (vehicle icon), and then touch the Software  tab to display the vehicle firmware version.
  2. Record the vehicle firmware version.
  3. Remove the center console. See CENTER CONSOLE (REMOVE AND INSTALL) .
  4. Disconnect 12V/LV power. See 12V/LV POWER - DISCONNECT AND CONNECT .
    WARNING: Make sure LV is disconnected before continuing to the next step.
    G14747945Courtesy of TESLA, INC.
  5. Release the locking tabs, and then disconnect the electrical harness from the restraint control module.
    G14747949Courtesy of TESLA, INC.
  6. Remove and discard the nuts (x3) that attach the restraint control module to the body, and then remove the module from the vehicle.
    NOTE: Use of the following tool(s) is recommended:
    • 10 mm socket
    • 2 in extension
    • 1/4 in std ratchet
    • 1/4 in torque wrench (installation only)
    G14747946Courtesy of TESLA, INC.
    G14747947Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals