Module - Restraint Control (Non-Heat Pump) Remove and Replace: Install
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Tesla Model 3, 2022 Tesla Model 3, 2021 Tesla Model 3, 2020 Tesla Model 3, and 2019 Tesla Model 3. However, it is still accessible from the selected car via links, so may be relevant.
- Install the restraint control module to the body, and then install new nuts (x3) to attach the module to the body.
8 N.m (5.9 ft-lbs)
NOTE: Use of the following tool(s) is recommended:- 10 mm socket
- 2 in extension
- 1/4 in std ratchet
- 1/4 in torque wrench (installation only)
- Connect the electrical harness to the restraint control module connectors.
- Connect 12V power. See 12V/LV POWER (DISCONNECT AND CONNECT) .
- Install the center console. See CENTER CONSOLE (REMOVE AND INSTALL) .
- Install the LH and RH center console side panel carpets. See SIDE PANEL - CENTER CONSOLE - LH (REMOVE AND REPLACE) .
- Install the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
- Park the vehicle on a level surface.
- Connect a laptop with Toolbox 3 to the vehicle.
- Perform the appropriate firmware operation based on the installed firmware version that was determined in step 1 of the removal procedure:
- If the vehicle firmware version is 2022.16.1 or newer, reinstall the vehicle firmware. See SOFTWARE REINSTALL .
- If the vehicle firmware version is older than 2022.16.1, update the vehicle firmware. See SOFTWARE UPDATE .
- In Toolbox, click the Dashboards tab, type "RCM retrofit" in the search field, click PROC_RCM_X_SERVICE-TASKS, click Run , and allow the routine to complete.
- If alerted to aim the headlights, perform the appropriate headlight aiming procedure:CAUTION: Do not return the vehicle to the customer until any alerts to aim the headlights have been addressed.
- Disconnect the laptop from the vehicle.