Fuse Box - Cabin - Front - Remove And Replace: Installation
- Install the new fuse box to vehicle.NOTE: Make sure the upper clips (x2) slide into the body and the bottom clips (x2) on to the bracket.
- Install a new nut that attaches the 12V input harness.
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Connect the electrical connectors (x10) to the fuse box.
- Reinstall the electrical connectors (x7) into the WIP harness bracket and slide it onto the fuse box bracket.NOTE: Connectors (x7) outer side
- Unfold the front portion of the RH front carpet.
- Install the RH footwell cover. See Assembly - Cover - Footwell - Passenger's (Remove and Replace) .
- Install the RH sill panel trim. See Trim - Sill Panel - LH (Remove and Replace) .
- Install the RH middle A-pillar trim. See Panel - A Pillar Trim - Middle - LH (Remove and Replace) .
- Install the RH instrument panel side cover. See Assembly - Instrument Panel Side Cover - LH (Remove and Replace) .
- Install the RH center console closeout extension. See Assembly - Closeout Extension - LH - Center Console (Remove and Replace) .
- Install the RH floor mat.
- Reconnect 12V power. See DISCONNECT 12V POWER .
- Install the outlet HEPA filter duct. See Duct - HEPA Filter - Outlet (Remove and Replace) .
- Install the inlet HEPA filter duct. See Duct - HEPA Filter - Inlet (Remove and Replace) .
- Install the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace) .
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .
- Close the hood.
- Restore the front passenger seat back to its original position.
- Close the RH front window and RH front door.