LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> Steering >> Manual Steering >> Power Assisted Steering System >> Repair Instructions >> Torque Sensor Inspection >> Using SUZUKI Scan Tool

Using SUZUKI Scan Tool

  1. Connect SUZUKI scan tool to DLC located on underside of instrument panel at driver's seat side.
  2. Push engine switch to change ignition mode of keyless push start system to "ON".
  3. Turn steering wheel fully clockwise and counterclockwise and check "Sensor (Main) Torque" and "Sensor (Sub) Torque" displayed on SUZUKI scan tool by selecting scan tool "Data list" mode. If check result is not as specified, perform Steps 4) to 7).

    Sensor torque 

    Approx. -11 N.m (-1.1 kgf-m, -8.5 lbf-ft) to 11 N.m (1.1 kgf-m, 8.5 lbf-ft) 

  4. Push engine switch to change ignition mode to "OFF".
  5. Separate steering lower shaft and steering gear case, see STEERING COLUMN REMOVAL AND INSTALLATION .
  6. Push engine switch to change ignition mode to "ON".
  7. Turn pinion shaft (steering gear case) to check "Sensor (Main) Torque" and "Sensor (Sub) Torque" displayed on SUZUKI scan tool. If check result is not as specified, replace steering gear case.

    Sensor torque 

    Approx. -11 N.m (-1.1 kgf-m, -8.5 lbf-ft) to 11 N.m (1.1 kgf-m, 8.5 lbf-ft) 

scientia non olet · About LEMON Manuals