LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> SX4 Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> DTC P0871: Transmission Fluid Pressure Sensor/Switch "C" Circuit Range/Performance >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
WARNING: If you do not select a suitable route and take proper precautions when performing a road test, an accident can occur.
  • Select a level road with no traffic to minimize the risk of accident.
  • Perform the test extremely carefully.
  • Perform the road test using 2 persons, a driver and an assistant.
NOTE:
  • If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
  • Check that the following conditions are satisfied when using this procedure.
    • Battery voltage > 10.5 V
    • 0.5 < Gear ratio < 1.0
  1. Drive with 30 - 50 km/h (19 mile/h - 31 mile/h) constantly for 40 sec. or more at "D" range. (Keep throttle valve opening constantly in this step).
  2. Stop vehicle and turn ignition switch to OFF position.
  3. Repeat Step  1) through  2) twice.
  4. Turn ignition switch to ON position.
scientia non olet · About LEMON Manuals