P/S System Specification and Service Data

P/S SYSTEM SPECIFICATION AND SERVICE DATA

Item		Specification
Hydraulic pressure Control	Relieved pressure	10400 kPa (106 kgf/cm² , 1508 psi)
	Control device	Flow control valve
	Control device	Relief valve
Power steering pressure switch		Switch turns on (closes) when the pressure is higher than 2, 500 - 3, 000 kPa (25 - 30 kgf/cm² , 356 - 427 psi). ECM uses this signal for idle speed control.
Specified fluid		Equivalent to ATF DEXRON®-II, (ESSO JWS 2326) or ATF DEXRON®-III
Fluid capacity of system		about 0.85 L (1.8/1.5 US/Imp pt.) CAUTION: The value is rough amount of fluid in entire system. Fluid level should be within "LOWER" and "UPPER" level marks on fluid reservoir, which means that appropriate amount of fluid is in it. (For details, refer to P/S FLUID LEVEL CHECK: HYDRAULIC TYPE .)
Steering Wheel Play		0 - 30 mm (0 - 1.2 in.)
Steering force		Less than 6.4 N.m (0.64 kgf-m, 4.6 lbf-ft) (Refer to STEERING FORCE CHECK: HYDRAULIC TYPE for procedure of force check.)
Accessory drive belt tension		Refer to ACCESSORY DRIVE BELT TENSION INSPECTION .