LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission System) >> Diagnostic information and Procedures >> DTC P0717: Input Speed Sensor A >> DTC Confirmation Procedure >> With SDT

With SDT

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch "ON". (Do not start engine.)
  2. Select "Data list" mode for "AT" with SDT.
  3. Start engine and maintain the following conditions for at least 5 consecutive seconds.

    VHCL/S SE-A/T: 40 km/h (25 MPH) or more 

    ENGINE SPEED: 1, 500 RPM or more 

    ACCELE POSI: 0.5/8 or more 

    SLCT LVR POSI: "D" position 

    GEAR (Input speed sensor 1): 4th or 5th position 

    GEAR (Input speed sensor 2): All position 

    Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test. 

  4. If DTC is detected, go to [Diagnosis Procedure ].
scientia non olet · About LEMON Manuals