LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Cruise Control System) >> Diagnostic Information and Procedures >> Cruise Control Switch Indicator Inoperative >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
  2. Disconnect the harness connector at the steering wheel controls switch - left.
  3. Cruise switch ON, test for less than infinite resistance between the steering wheel control supply voltage terminal 1 and the cruise control indicator dimming signal circuit terminal 9 at the terminals of the steering wheel controls switch - left.
    • If the resistance measured is infinite, replace the steering wheel controls switch - left.
  4. Igniting OFF, verify that a test lamp illuminates between B+ and the cruise control indicator dimming signal circuit terminal 9.
    • If the test lamp does not illuminate, test the cruise control indicator dimming signal circuit for an open/high resistance.
  5. If all circuits test normal, replace the BCM.
scientia non olet · About LEMON Manuals