LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Power Assisted Steering System) >> Repair Instructions >> Power Steering Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power steering pump to the vehicle through the right wheel house area.
    CAUTION:

    Refer to FASTENER NOTICE .

    Fig 1: Identifying Power Steering Pump Bolts
    G04844009Courtesy of SUZUKI OF AMERICA CORP.
  2. Install the power steering pump bolts (1).

    Tightening torque 

    Tighten to 50 N.m (37 lb ft). 

    Fig 2: Identifying Power Steering Gear Inlet Hose
    G04844010Courtesy of SUZUKI OF AMERICA CORP.
  3. Connect the power steering gear inlet hose (1) to the power steering pump.

    Tightening torque 

    Tighten to 25 N.m (18 lb ft). 

    Fig 3: Identifying Power Steering Reservoir Outlet Hose Clamp & Power Steering Reservoir Outlet Hose
    G04844011Courtesy of SUZUKI OF AMERICA CORP.
  4. Compress the power steering reservoir outlet hose clamp (1) and connect the power steering reservoir outlet hose (2) to the power steering pump.
  5. Install the right side engine splash shield. Refer to ENGINE SPLASH SHIELD REPLACEMENT - RIGHT SIDE .
  6. Clean any excess fluid from the vehicle.
  7. Install the drive belt. Refer to INSTALLATION PROCEDURE .
  8. Fill and bleed the power steering system. Refer to POWER STEERING SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals