LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Power Assisted Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the steering gear inlet hose to the vehicle.
    Fig 1: Identifying Power Steering Gear Inlet Hose
    G04844024Courtesy of SUZUKI OF AMERICA CORP.
    CAUTION:

    Refer to FASTENER NOTICE .

    NOTE:

    Hand tighten the power steering gear inlet hose fittings before finalizing the torques.

  2. Connect the power steering gear inlet hose fitting (1) to the steering gear.

    Tightening torque 

    Tighten the fitting to 25 N.m (18 lb ft). 

    Fig 2: Identifying Power Steering Gear Inlet Hose From Power Steering Pump
    G04844025Courtesy of SUZUKI OF AMERICA CORP.
  3. Connect the power steering gear inlet hose fitting (1) to the power steering pump.

    Tightening torque 

    Tighten the fitting to 25 N.m (18 lb ft). 

  4. Clean any excess fluid from the vehicle and remove the drain pans.
  5. Install the front tire/wheel assemblies. Refer to INSTALLATION PROCEDURE .
  6. Fill and bleed the power steering system. Refer to POWER STEERING SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals