LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Power Assisted Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power steering cooler pipe to the vehicle.
  2. Reconnect all power steering cooler pipe routing brackets to the vehicle.
    Fig 1: Identifying Power Steering Cooler Pipe
    G04844015Courtesy of SUZUKI OF AMERICA CORP.
    CAUTION:

    Refer to FASTENER NOTICE .

  3. Connect the power steering cooler pipe fitting (1) to the power steering gear.

    Tightening torque 

    Tighten to 25 N.m (18 lb ft). 

    Fig 2: Identifying Power Steering Cooler Pipe Clamp & Power Steering Cooler Pipe
    G04844016Courtesy of SUZUKI OF AMERICA CORP.
  4. Compress the power steering cooler pipe clamp (1) and connect the power steering cooler pipe (2) to the remote power steering fluid reservoir.
  5. Clean any excess fluid from the vehicle and remove the drain pans.
  6. Install the left side engine splash shield. Refer to ENGINE SPLASH SHIELD REPLACEMENT - LEFT SIDE .
  7. Install the front tire/wheel assemblies. Refer to INSTALLATION PROCEDURE .
  8. Install the air cleaner outlet duct. Refer to INSTALLATION PROCEDURE .
  9. Install the fuel injector sight shield. Refer to INSTALLATION PROCEDURE .
  10. Fill and bleed the power steering system. Refer to POWER STEERING SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals