Circuit / System Verification
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, while opening and closing each vehicle door, verify that the applicable scan tool door ajar switch parameter cycles between Closed and Ajar.
- If the scan tool parameter does not cycle between the specified values, refer to DOOR AJAR INDICATOR MALFUNCTION .
- With the rear compartment lid open, verify the GATE AJAR indicator is illuminated on the DIC.
- If the message is not displayed, refer to REAR HATCH / GATE AJAR INDICATOR INOPERATIVE .
- With the rear compartment lid closed, verify the Gate AJAR indicator is not illuminated on the DIC.
- If the message is displayed, refer to REAR HATCH / GATE AJAR INDICATOR ALWAYS ON .
- Completely lower the driver door window.
- Ignition OFF, arm the CTD system using the keyless entry system by pressing the transmitter LOCK button twice. Verify the scan tool CTD Status parameter displays Armed.
- If the parameter does not equal the specified value, refer to KEYLESS ENTRY SYSTEM INOPERATIVE .
- Without disarming the system, reach in through the open driver window, unlock and open the driver door. Verify the scan tool CTD Status parameter displays Alarm Active.
- If the parameter does not equal the specified value, replace the BCM.
- With the door open, verify the vehicle horn is pulsing and the exterior lamps are flashing.
- If the horn is not pulsing, refer to HORNS MALFUNCTION .
- If the exterior lights are not flashing, refer to TURN SIGNAL LAMPS AND / OR INDICATORS INOPERATIVE .