LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Immobilizer System) >> Diagnostic Information and Procedures >> DTC B3031 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When performing a 10-Minute Vehicle Key Relearn Procedure, all keys not learned at that time will be erased and not be recognized. Perform the Adding Keys procedure on all keys or instruct the customer how to perform the Adding Keys procedure should all keys not be present at the time of repair.
  1. Verify DTC B3060 is not set as current.
    • If DTC B3060 is set as current, refer to DTC B3060 .
  2. With a scan tool, verify the scan tool TDM Learn Coded Key parameter displays Active.
    • If not the specified value, perform the 10 Minute Vehicle Key Relearn procedure. Refer to REPLACING KEYS .
  3. Perform the 10 Minute Vehicle Key Relearn procedure. Refer to REPLACING KEYS . The TDM should exit the learn coded key state and DTC B3031 should clear.
    • If the TDM does not exit the learn coded key state after the programming attempt, replace the TDM.
scientia non olet · About LEMON Manuals