Circuit/System Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the headlamp switch.
- Ignition OFF, test for less than 1 Ω of resistance between the ground circuit and ground.
- If greater than 1 Ω, test the ground circuit for an open/high resistance.
- Verify the headlamps are OFF.
- If the headlamps are not OFF, test the signal circuit for a short to ground. If the circuit tests normal, replace the BCM.
- Install a 3-amp fused jumper wire between the signal circuit and ground. Verify the headlamps are ON.
- If the headlamps are not ON, test the signal circuit of the headlamp switch for a short to voltage or an open/high resistance. If circuit tests normal, replace the BCM.
- If all circuits test normal, test or replace the headlamp switch.