LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Data Communication System) >> Diagnostic Information & Procedures >> DTC U2105-U2199 (Except U2142 and U2143) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the DTC Descriptor and Diagnostic Aids above, determine the module that is not communicating that should be tested.
  2. Ignition OFF, disconnect the harness connector of the module that is not communicating.
  3. Ignition ON, verify that a test lamp illuminates between all battery positive voltage circuits and ground.
    • If the test lamp does not illuminate, repair the circuit for a short to ground or an open/high resistance. If the circuit fuse is open, also test the positive voltage outputs of the module for a short to ground. If the circuits test normal, replace the faulty module.
  4. Verify that a test lamp illuminates between all ignition voltage circuits and ground.
    • If the test lamp does not illuminate, repair the circuit for a short to ground or an open/high resistance. If the circuit fuse is open, also test the positive voltage outputs of the module for a short to ground. If the circuits test normal, replace the faulty module.
  5. Test for less than 1 Ω of resistance between the module ground circuits and ground.
    • If greater than 1 Ω, repair the ground circuit for an open.
  6. If all circuits test normal, replace the module that is not communicating.
scientia non olet · About LEMON Manuals